Endress+Hauser Proline Prosonic Flow P 500 - Post-Mounting Check

Proline Prosonic Flow P 500 HART Mounting
Endress+Hauser 45
N
i
c
h
t
u
n
t
e
r
a
r
e
ö
f
f
n
e
n
+
E
ESC
–
1.
2.
N
i
c
h
t
u
n
t
e
r
a
r
e
ö
f
f
n
e
n
+
E
ESC
–
3.
3 mm
+
E
ESC
–
A0030035
1. Depending on the device version: Loosen the securing clamp of the connection
compartment cover.
2. Unscrew the connection compartment cover.
3. Turn the display module to the desired position: max. 8 × 45° in each direction.
4. Screw on the connection compartment cover.
5. Depending on the device version: Attach the securing clamp of the connection
compartment cover.
6.3 Post-mounting check
Is the measuring device undamaged (visual inspection)? 
Does the measuring device correspond to the measuring point specifications?
For example:
• Process temperature →  206
• Inlet run conditions
• Ambient temperature
• Measuring range

Has the correct orientation for the sensor been selected →  19?
• According to sensor type
• According to medium temperature
• According to medium properties (outgassing, with entrained solids)

Are the sensors correctly connected to the transmitter (upstream/downstream) ? 
Are the sensors correctly mounted (distance, 1 traverse, 2 traverses) →  22? 
Is the tag name and labeling correct (visual inspection)? 
Is the device sufficiently protected from precipitation and direct sunlight? 
Are the securing screw and securing clamp tightened securely? 
Is the sensor holder properly grounded (in the event of different potential between the sensor
holder and transmitter)?
