Endress+Hauser Proline Prosonic Flow P 500 - Configuring the Status Input

Proline Prosonic Flow P 500 HART Commissioning
Endress+Hauser 105
Navigation
"Setup" menu → I/O configuration
‣
I/O configuration
I/O module 1 to n terminal numbers
→  105
I/O module 1 to n information
→  105
I/O module 1 to n type
→  105
Apply I/O configuration
→  105
I/O alteration code
→  105
Parameter overview with brief description
Parameter Description User interface / Selection /
User entry
Factory setting
I/O module 1 to n terminal numbers Shows the terminal numbers used by the I/O
module.
• Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
I/O module 1 to n information Shows information of the plugged I/O
module.
• Not plugged
• Invalid
• Not configurable
• Configurable
• HART
–
I/O module 1 to n type Shows the I/O module type. • Off
• Current output
*
• Current input
*
• Status input
*
• Pulse/frequency/switch
output
*
• Double pulse output
*
• Relay output
*
Off
Apply I/O configuration Apply parameterization of the freely
configurable I/O module.
• No
• Yes
No
I/O alteration code Enter the code in order to change the I/O
configuration.
Positive integer 0
* Visibility depends on order options or device settings
10.4.6 Configuring the status input
The Status input submenu guides the user systematically through all the parameters that
have to be set for configuring the status input.
Navigation
"Setup" menu → Status input 1 to n
‣
Status input 1 to n