Endress+Hauser Proline Prosonic Flow P 500 - Pulse;Frequency;Switch Output; Operating Mode

Commissioning Proline Prosonic Flow P 500 HART
112 Endress+Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Failure mode The Pulse option is selected in
the Operating mode
parameter (→  110) and a
process variable is selected in
the Assign pulse output
parameter (→  111).
Select output behavior in the
event of a device alarm.
• Actual value
• No pulses
No pulses
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  113
Terminal number
→  113
Signal mode
→  113
Assign frequency output
→  113
Minimum frequency value
→  113
Maximum frequency value
→  113
Measuring value at minimum
frequency
→  113
Measuring value at maximum
frequency
→  113
Failure mode
→  114
Failure frequency
→  114
Invert output signal
→  114