Endress+Hauser Proline Prosonic Flow P 500 - 10.4.13 Configuring the Low Flow Cut off

Proline Prosonic Flow P 500 HART Commissioning
Endress+Hauser 123
Parameter Prerequisite Description Selection / User
entry
Factory setting
Value 6 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  122)
None
Value 7 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  122)
None
Value 8 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
Value 1 display
parameter
(→  122)
None
* Visibility depends on order options or device settings
10.4.13 Configuring the low flow cut off
The Low flow cut off wizard systematically guides the user through all the parameters
that must be set to configure low flow cut off.
Structure of the wizard
Volume flow
Assign variable
Off value
End of wizard
Off
On value
Mass flow Flow velocity
A0043342-EN
 68 "Low flow cutoff" wizard in the "Setup" menu
Navigation
"Setup" menu → Low flow cut off
‣
Low flow cut off
Assign process variable (1837)
→  124
On value low flow cutoff (1805)
→  124
Off value low flow cutoff (1804)
→  124