Endress+Hauser Proline Prosonic Flow P 500 - Disposal; Disposing of the Measuring Device; Removing the Measuring Device

Repair Proline Prosonic Flow P 500 HART
188 Endress+Hauser
14.5 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the product is marked with the depicted symbol in order to minimize the
disposal of WEEE as unsorted municipal waste. Do not dispose of products bearing this
marking as unsorted municipal waste. Instead, return them to the manufacturer for
disposal under the applicable conditions.
14.5.1 Removing the measuring device
1. Switch off the device.
L
WARNING
Danger to persons from process conditions!
‣
Pay attention to high temperatures.
2. Carry out the mounting and connection steps from the "Mounting the measuring
device" and "Connecting the measuring device" sections in reverse order. Observe the
safety instructions.
14.5.2 Disposing of the measuring device
Observe the following notes during disposal:
‣
Observe valid federal/national regulations.
‣
Ensure proper separation and reuse of the device components.