Endress+Hauser Proline Prosonic Flow P 500 - Integrating the Transmitter into a Network

Electrical connection Proline Prosonic Flow P 500 HART
54 Endress+Hauser
7.3.3 Integrating the transmitter into a network
This section only presents the basic options for integrating the device into a network.
For information on the procedure to follow to connect the transmitter correctly →  49.
Integrating via the service interface
The device is integrated via the connection to the service interface (CDI-RJ45).
Note the following when connecting:
• Recommended cable: CAT 5e, CAT 6 or CAT 7, with shielded connector (e.g. brand:
YAMAICHI ; Part No Y-ConProfixPlug63 / Prod. ID: 82-006660)
• Maximum cable thickness: 6 mm
• Length of plug including anti-bend protection: 42 mm
• Bending radius: 5 x cable thickness
N
i
c
h
t
u
n
t
e
r
a
r
e
ö
f
f
n
e
n
Nicht unter
Spannung öffnen
Do not open when
energized
Ne pas ouvrir
sous tension
Power
I/O
≤
42 (1.6)
1
A0033703
1 Service interface (CDI-RJ45)
An adapter for the RJ45 (non-Ex) to the M12 plug is optionally available:
Order code for "Accessories", option NB: "Adapter RJ45 M12 (service interface)"
The adapter connects the service interface (CDI-RJ45; non-Ex) to an M12 plug
mounted in the cable entry. The connection to the service interface can therefore be
established via an M12 plug without opening the device.