Endress+Hauser Proline Prosonic Flow P 500 - Default Chapter; System Values

Proline Prosonic Flow P 500 HART Operation
Endress+Hauser 149
Parameter Prerequisite Description User interface Factory setting
API slope For the following order code:
• "Application package", option
EJ "Petroleum"
• "Application package", option
EQ "Petroleum & Product
identification"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Shows the API slope (change
of API over time). Can be used
e.g. to detect different
products.
–10 to 100 °API/s –
Reference density For the following order code:
• "Application package", option
EJ "Petroleum"
• "Application package", option
EQ "Petroleum & Product
identification"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Shows the reference density at
the API reference conditions
specified for temperature and
pressure.
0 to 30 kg/Nm³ –
11.4.2 System values
The System values submenu contains all the parameters needed to display the current
measured values for every system value.
Navigation
"Diagnostics" menu → Measured values → System values
‣
System values
Signal strength
→  150
Acceptance rate
→  150
Signal to noise ratio
→  150
Turbulence
→  150