Endress+Hauser Proline Prosonic Flow P 500 - Page 148

Operation Proline Prosonic Flow P 500 HART
148 Endress+Hauser
Parameter Prerequisite Description User interface Factory setting
NSV flow For the following order code:
• "Application package", option
EJ "Petroleum"
• "Application package", option
EQ "Petroleum & Product
identification"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the net volume flow
which is calculated from the
measured total volume flow
minus the value for sediment
& water and minus the
shrinkage.
Dependency
The unit is taken from:
Corrected volume flow unit
parameter
Signed floating-point
number
–
S&W correction value For the following order code:
• "Application package", option
EJ "Petroleum"
• "Application package", option
EQ "Petroleum & Product
identification"
• The External value option
or Current input 1…n
option is selected in the
S&W input mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Shows the correction value for
sediment and water.
Positive floating-
point number
–
S&W volume flow For the following order code:
• "Application package", option
EJ "Petroleum"
• "Application package", option
EQ "Petroleum & Product
identification"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the S&W volume flow
which is calculated from the
measured total volume flow
minus the net volume flow.
Dependency
The unit is taken from:
Volume flow unit parameter
Signed floating-point
number
–
API gravity For the following order code:
• "Application package", option
EJ "Petroleum"
• "Application package", option
EQ "Petroleum & Product
identification"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the reference density
in API degrees (specified
depending on the option, or
read in by an external device).
0.0 to 100.0 °API –