Endress+Hauser Proline Prosonic Flow P 500 - Commissioning the Device; Pre-Commissioning Checks; Setting the Operating Language

Commissioning Proline Prosonic Flow P 500 HART
94 Endress+Hauser
10 Commissioning
10.1 Post-mounting and post-connection check
Before commissioning the device:
‣
Make sure that the post-installation and post-connection checks have been performed
successfully.
• Checklist for "Post-mounting" check→  45
• Checklist for "Post-connection check" →  59
10.2 Switching on the measuring device
‣
Switch on the device upon successful completion of the post-mounting and post-
connection check.
 After a successful startup, the local display switches automatically from the startup
display to the operational display.
• If nothing appears on the local display or if a diagnostic message is displayed, refer
to the section on "Diagnostics and troubleshooting" →  159.
• If diagnostic information 104, 105 or 106 appears on the local display, then the
measuring point is not yet correctly mounted/configured →  172.
10.3 Setting the operating language
Factory setting: English or ordered local language
X X X X X X XX X
20.50
Operation
Setup
Main menu
0104-1
Display language
English
Español
Français
Display language
English
Deutsch
Ã
0104-1
Ã
Español
Français
Display language
English
Deutsch
0104-1
Betrieb
Setup
Hauptmenü
Sprache
Deutsch
0104-1
XXXX
1.
2.
3.
4.
A0029420
 65 Taking the example of the local display
10.4 Configuring the measuring device
The Setup menu with its guided wizards contains all the parameters needed for standard
operation.