Endress+Hauser Proline Prosonic Flow P 500 - Configuring the Pulse;Frequency;Switch Output; Default Chapter; Configuring the Pulse;Frequency; Switch Output

Commissioning Proline Prosonic Flow P 500 HART
110 Endress+Hauser
10.4.9 Configuring the pulse/frequency/switch output
The Pulse/frequency/switch output wizard guides you systematically through all the
parameters that can be set for configuring the selected output type.
Navigation
"Setup" menu → Advanced setup → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  110
Parameter overview with brief description
Parameter Description Selection Factory setting
Operating mode Define the output as a pulse, frequency or
switch output.
• Pulse
• Frequency
• Switch
Pulse
Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  111
Terminal number
→  111
Signal mode
→  111
Assign pulse output
→  111
Pulse scaling
→  111
Pulse width
→  111
Failure mode
→  112
Invert output signal
→  112