Endress+Hauser Proline Prosonic Flow P 500 - Page 124

Commissioning Proline Prosonic Flow P 500 HART
124 Endress+Hauser
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Assign process variable – Select process variable for low
flow cut off.
• Off
• Volume flow
• Mass flow
• Flow velocity
Flow velocity
On value low flow cutoff A process variable is selected
in the Assign process variable
parameter (→  124).
Enter on value for low flow cut
off.
Positive floating-
point number
Depends on country
and nominal
diameter
Off value low flow cutoff A process variable is selected
in the Assign process variable
parameter (→  124).
Enter off value for low flow cut
off.
0 to 100.0 % 50 %