Endress+Hauser Proline Prosonic Flow P 500 - Page 114

Commissioning Proline Prosonic Flow P 500 HART
114 Endress+Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Failure mode The Frequency option is
selected in the Operating
mode parameter (→  110)
and a process variable is
selected in the Assign
frequency output parameter
(→  113).
Select output behavior in the
event of a device alarm.
• Actual value
• Defined value
• 0 Hz
0 Hz
Failure frequency In the Operating mode
parameter (→  110), the
Frequency option is selected,
in the Assign frequency
output parameter (→  113)
a process variable is selected,
and in the Failure mode
parameter, the Defined value
option is selected.
Enter frequency output value
in alarm condition.
0.0 to 12 500.0 Hz 0.0 Hz
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings