Endress+Hauser Proline Prowirl R 200 - Page 89

Proline Prowirl R 200 HART Commissioning
Endress+Hauser 89
Parameter Prerequisite Description Selection / User
entry
Factory setting
Measuring value at minimum
frequency
In the Operating mode
parameter, the Frequency
option is selected, and one of
the following options is
selected in the Assign
frequency output parameter
(→  88):
• Volume flow
• Corrected volume flow
• Mass flow
• Flow velocity
• Temperature
• Pressure
• Calculated saturated steam
pressure
*
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Enter measured value for
minmum frequency.
Signed floating-point
number
Depends on country
and nominal
diameter
Measuring value at maximum
frequency
In the Operating mode
parameter, the Frequency
option is selected, and one of
the following options is
selected in the Assign
frequency output parameter
(→  88):
• Volume flow
• Corrected volume flow
• Mass flow
• Flow velocity
• Temperature
• Pressure
• Calculated saturated steam
pressure
*
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Enter measured value for
maximum frequency.
Signed floating-point
number
Depends on country
and nominal
diameter
Failure mode In the Operating mode
parameter (→  85), the
Frequency option is selected,
and one of the following
options is selected in the
Assign frequency output
parameter (→  88):
• Volume flow
• Corrected volume flow
• Mass flow
• Flow velocity
• Temperature
• Pressure
• Calculated saturated steam
pressure
*
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Define output behavior in
alarm condition.
• Actual value
• Defined value
• 0 Hz
0 Hz