Endress+Hauser Prosonic S FMU90 - Installation; 3.1 Incoming acceptance, transport, storage; 3.2 Mounting the field housing

Notes on use
12
Selecting a parameter
By pressing U or T you can switch between the parameter sets of the current submenu. For each
parameter set the values of all its parameters are displayed. In order to change one of the values,
proceed as follows:
!
Note!
If necessary, you can exit the parameter and parameter set by pressing .
L00-FMU90xxx-19-00-00-en-040
1. Press U or T, until you have reached the
required parameter set.
2. Press ↵, in order to enter the parameter set.
3. Select the required parameter by pressing
W or V.
(This step is not required if the set contains
only one parameter.)
4. Press ↵, in order to enter the editing mode
of the parameter.
The editing method depends on the type of
parameter (selection list, numeric or
alphanumeric parameter). For details refer
to the following sections.
1.
1.
3.
2.
4.