The "display" menu
152
"time"
This parameter is used for the options "value max. size" and "alter 3x2 values". It specifies the time
after which the next page appears.
!
Note!
To change to the next page immediately, press .
"value 1" ... "value 6"
Use these parameters to allocate a measured or calculated value to each of the display values. The
selection depends on the instrument version and installation environment.
!
Note!
If "temp. sensor 1/2" is selected, depending on the setting in "sensor management/FDU sensor N"
one of the following is displayed:
• the sensor temperature
• the average of the sensor temperature and the temperature of the external temperature probe
• the temperature of the external temperature probe
"cust. text 1" ... "cust. text 6"
These parameters can be used to allocate a text string to each of the display values. This text is
displayed together with the value if "customized text" (in the "display format" parameter set) has
been set to "yes".
10.2 "display format"
"format"
Use this parameter to select the display format for numbers.
Selection:
• decimal (Default)
•ft-in-1/16"
"no. of decimals"
Use this parameter to select the number of decimals for the representation of numbers.
Selection:
•x
•x.x
• x.xx (Default)
•x.xxx
"sep. character"
Use this parameter to select the separation character for the representation of decimal numbers.
Selection:
• point (.) (Default)
•comma (,)
"customized text"
⇒
display format DX201
format:
no. of decimals:
sep. character:
customized text:
To Next Page
Loading...
