Endress+Hauser Prosonic S FMU90 - 12.7 Adaption plate for remote display; 12.8 Overvoltage protection (in IP66 housing)

The "sensor management" menu
154
11 The "sensor management" menu
11.1 The "sensor management" submenu
Upon entering this menu, a selection list appears, from which you can select a sensor for
parametrization.
11.1.1 "US sensor N" (N = 1 or 2)
(sensor settings)
"sensor operation"
This parameter is used to switch the sensor on and off.
Selection:
• on (default)
The sensor is switched on.
• hold
The sensor is switched off. The last measured value is held.
• off
The sensor is switched off. No measured value is transmitted.
On the display, connected values are set to "-----------".
⇒
input DX019
FDU sensor 1:
(FDU sensor 2:)
⇒
US sensor 1 D1106
sensor operation:
sensor priority:
detected:
sensor selection: