Endress+Hauser Prosonic S FMU90 - Editing a Parameter with Selection List

Notes on use
13
Editing a parameter with selection list
!
Note!
By pressing before  you can quit the parameter without accepting your changes.
L00-FMU90xxx-19-00-00-en-041
1. Press W or V, until the required option is
marked by the bar (in the example: "turb.
surface").
!
Note!
The symbols indicate that the
selection list contains more items than can
be displayed on the module. Press W or V
several times, to mark one of the hidden
items.
2. Press Â, in order to select the marked
option. It is then stored in the instrument.
3. Press the left and middle keys
simultaneously in order to quit the
parameter.
The software key symbols U and T
reappear and you can switch to the next
parameter set.
1.
2.
3.