Notes on use
14
Entering numbers and characters
L00-FMU90xxx-19-00-00-yy-042
When you select a numeric parameter ("empty
calibration", "full calibration" etc.) or an alpha-
numeric parameter ("device marking" etc.), the
editor for numbers and text strings appears.
Enter the desired value in the following way:
1. The cursor is at the first digit. Press S or O
until this digit has the required value.
2. Press ↵ in order to confirm the value and to
jump to the next digit.
3. Repeat the procedure for all relevant digits.
4. If all relevant digits have been entered:
Press S or O, until ↵ appears at the cursor.
5. Press ↵ to store the complete value in the
device.
6. Press the left and middle keys simultane-
ously in order to quit the parameter.
1.
2.
3.
4.
5.
6.
To Next Page
Loading...
