The "device properties" menu
137
8.1.4 "controls"
(only available for the "level" and "level + flow" operating modes)
Use this parameter to specify which controls the Prosonic S is to perform.
Selection:
•no (default)
• pump control
• rake control
8.2 The "tag marking" submenu
8.2.1 "tag marking"
"output N" (N = 1 or 2) (only for HART instruments)
Use these parameters to define a tag (designation) for the current output. The tag may consist of up
to 16 alphanumeric characters.
"device marking"
Use this parameter to define a tag (designation) for the entire instrument. The tag may consist of up
to 16 alphanumeric characters.
⇒
controls D110D
controls:
⇒
tag marking D1102
output 1:
output 2:
device marking:
To Next Page
Loading...
