Endress+Hauser Prosonic S FMU90 - 3 The Flow Menu; The Flow N Submenu (N = 1 or 2)

The "flow" menu
37
3 The "flow" menu
The "flow" submenu is used for the calibration of
• flow measurements (1 or 2 channels)
• back water alarm
•flow counters
The structure of the submenu depends on the selected operating mode
5)
:
L00-FMU90xxx-19-00-00-en-076
Always start by calibrating the first flow channel ("flow 1" submenu).
Thereafter, you can calibrate the following as required:
• the second flow channel ("flow 2" submenu)
• the backwater detection ("backwater" submenu)
• the flow counters ("flow counter" submenu)
3.1 The "flow N" submenu (N = 1 or 2)
!
Note!
The "flow 2" submenu is only available for instruments with 2 sensor inputs. It is identical to the
"flow 1 " submenu.
5) The operating mode is selected during the first setup. Nevertheless, it can be changed at any time if required ("device properties" menu, "operating params"
submenu, "operating mode" parameter set).
main menu
flow
flow
flow
flow counter
flow
flow 1
flow 2
main menu
flow
flow
flow1+backwater
flow counter
flow1+backwater
flow
backwater
operating modes
“level+flow”
“flow”
operating mode
“flow+backwater”
⇒
flow 1 F1002
basic setup
extended calibr.
simulation