Endress+Hauser Prosonic S FMU90 - LVL N Unit; Unit Level; Distance

The "level" menu
23
2.1.5 "LVL N unit" (N = 1 or 2)
"unit level"
Use this parameter to select the level unit.
If no linearization is performed, the level is displayed in this unit.
Selection:
•m
•ft
•inch
•mm
• % (Default)
"
Caution!
After a change of the level unit, the switching points of the limit and pump control relays have to
be checked and to be adjusted if required.
"level N" (N = 1 or 2)
Displays the currently measured level F (from the zero point to the product surface) in the selected
unit.
L00-FMU90xxx-19-00-00-yy-021
"distance"
Displays the currently measured distance D (from the sensor membrane to the product surface) in
the distance unit. If the display value does not match the real distance, an interference echo
suppression must be performed prior to linearization.
L00-FMU90xxx-19-00-00-yy-022
⇒
LVL 1 unit L1007
unit level:
level 1:
distance:
0/4 mA
0%
F
D