The "sensor management" menu
156
"detection window"
Is used to switch the detection window on and off and to reset an existing detection window.
If this function is switched on, a window is defined surrounding the current level echo (typical
width: 1 to 2.5 m; depending on the application parameters).
The window always moves togehter with a rising or falling echo.
Echos beyond the limits of the window are ignored for a certain time.
!
Note!
This parameter is set automatically according to the application parameters.
Selection:
• off
•on
• reset
After selection of this option, the current window is reset, the level echo is looked for in the
complete measuring range and a new window is defined surrounding the current level echo.
To Next Page
Loading...
