The "relays/controls" menu
71
5 The "relays/controls" menu
5.1 The "relay configuration" submenu
5.1.1 "relay allocation"
Use this parameter to select the relay you are going to configure.
Selection:
• All relays of the instrument version at hand
!
Note!
If a function has already been allocated to one of the relays, the name of this function is displayed
next to the relay number.
5.1.2 "relay 1...6"
(relay function)
After selecting a relay, the "relay N" (N = 1 ... 6) parameter set appears, which is used to configure
the relay.
To configure the relay, proceed according to the following steps:
1. Select the "function" parameter. The "select function" screen appears.
2. Select one of the following functions:
a. limit
After selecting this option, a further selection list appears. Select the measuring value to
which the limit relay is to be allocated.
Continue by sections 5.1.3 and 5.1.11.
b. time pulse (only for flow measurements)
(outputs a short pulses at regular time intervals)
After selecting this option, a further selection list appears. Select the option "time pulse".
Continue by sections 5.1.4 and 5.1.11.
c. counting pulse (only for flow measurements)
(outputs a short pulse after a defined flow volume)
After selecting this option, a further selection list appears. Select the measuring value to
which the pulses refer.
Continue by sections 5.1.5, 5.1.6 and 5.1.11.
d. alarm/diagnostics
⇒
relay allocation RX101
relay 1
relay 2
relay 3
relay 4
⇒
relay 2 R1103
function:
To Next Page
Loading...
