EnGenius EOC1650 - Snmp Settings

EnGenius EOC1650 Wireless Access Point / Client Bridge Version 2.0
38

 Name:Specifyausernameintothefirstfield.
 Password: Specify a password into this field and then re‐type the password into the Confirm
Passwordfield.
 ClickontheApplybuttontosavethechanges.


5.5.2 SNMPSettings
 ClickontheSNMPSettingslinkundertheManagementmenu.Thisoptionallows youtoassign
the contact details, location, and community name and trap settings for SNMP. This is a
networking management protocol used to monitor network‐attached devices. SNMP allows
messages (called protocol data units) to be sent to
 various parts of a network. Upon receiving
these messages, SNMP‐compatible devices (called agents) return data stored in their
ManagementInformationBases.


 SNMPEnable/Disable:ChoosetoenableordisabletheSNMPfeature.
 Contact:Specifythecontactdetailsofthedevice.
 Location:Specifythelocationofthedevice.
 Read‐Only Community Name: Specify the password for access the SNMP community for read
onlyaccess.
 Read‐Write
 Community Name: Specify the password for access to the SNMP community with
read/writeaccess.
 SendSNMPTrap:SpecifytheIPaddressofthecomputerthatwillreceivetheSNMPtraps.
 TrapCommunityName:SpecifythepasswordfortheSNMPtrapcommunity.
 ClickontheApplybuttontosavethechanges.

