EnGenius EOC1650 - 5.5.3 Backup;Restore settings, Reset to factory default settings; 5.5.4 Firmware Upgrade

EnGenius EOC1650 Wireless Access Point / Client Bridge Version 2.0
39
5.5.3 Backup/Restoresettings,Resettofactorydefaultsettings
 Click on the Backup/Restore Setting link under the Management menu. This option is used to
savethecurrentsettingsofthedeviceinafileonyourlocaldiskorloadsettingsontothedevice
from a local disk. This feature is very handy for administrators who have several
 devices that
needtobeconfiguredwiththesamesettings.

 Saveacopyofthecurrentsettings:ClickontheBackupbuttontosavethecurrentconfiguration.
 Restoresavedsettingsfromafile:Onceafilehasbeenbackedup,youmayrestoreitbyclicking
ontheBrowsebuttontoselectthefile,andthentheRestore
button.
 Revert to factory default settings: Click on the Factory Default Settings button to reset the
device to the default settings. Please wait while the device restart and then access the device
usingthedefaultIPaddress:192.168.1.1




5.5.4 FirmwareUpgrade
 ClickontheUpgradeFirmwarelinkundertheManagementmenu.Thispageisusedtoupgrade
the firmware on the device. Make sure that downloaded the appropriate firmware from your
vendor.

 Click on the Browse button and then select the appropriate firmware and then click  on the
Upgradebutton.
Note:Theupgradeprocess maytakeabout1 minutetocomplete.Do not poweroffthedevice
during this process as it may crash the device and make it unusable. The
device will restart
automaticallyoncetheupgradeiscomplete.

