EnGenius EOC1650 - 7.4.1.3 WAN - PPPOE

EnGenius EOC1650 Wireless Access Point / Client Bridge Version 2.0
60


 InternetConnectionType:SelecttheStaticIPfromthedrop‐downlist.
 AccountName:SpecifyanaccountnameifyourISPhasprovidedyouwithone.
 DomainName:SpecifyadomainnameiftheISPhasprovidedyouwithone.
 MTU: The Maximum Transmission
 Unit (MTU) is a parameter that determines the largest
packet size (in bytes) that the router will send to the WAN. If LAN devices send larger
packets, the router will break them into smaller packets. Ideally, you should set this to
matchtheMTUoftheconnectionto yourISP.
Typicalvaluesare1500bytesforanEthernet
connection and 1492 bytes for a PPPoE connection. If the router's MTU is set too high,
packetswill befragmented downstream. Iftherouter's MTUis settoo low,therouter will
fragment packets unnecessarily and in extreme cases may be unable to
 establish some
connections.Ineithercase,networkperformancecan suffer.
 IPAddress:SpecifytheIPaddressforthisdevice,whichisassignedbyyourISP.
 SubnetMask:SpecifythesubnetmaskforthisIPaddress,whichisassignedbyyourISP.
 Gateway IP Address: Specify the IP
address of the default gateway, which  is assigned by
yourISP.
 DomainNameService:SpecifytheprimaryandsecondaryDNSserverIPaddress.
 ClickontheApplybuttontosavethechanges.


7.4.1.3 WAN–PPPoE
 TheWANinterfacecanbeconfiguredasPPPoE.Thistypeofconnectionisusuallyusedfora
DSLserviceandrequiresausernameandpasswordtoconnect.
