EnGenius EOC1650 Wireless Access Point / Client Bridge Version 2.0
61
InternetConnectionType:SelectPPPoEfromthedrop‐downlist.
MTU: The Maximum Transmission Unit (MTU) is a parameter that determines the largest
packet size (in bytes) that the router will send to the WAN. If LAN devices send larger
packets, the router will break them into
smaller packets. Ideally, you should set this to
matchtheMTUoftheconnectionto yourISP.Typicalvaluesare1500bytesforanEthernet
connection and 1492 bytes for a PPPoE connection. If the router's MTU is set too high,
packetswill befragmented downstream. Iftherouter's MTU
issettoo low,therouterwill
fragment packets unnecessarily and in extreme cases may be unable to establish some
connections.Ineithercase,networkperformancecan suffer.
Login:SpecifytheusernamewhichisprovidedbyyourISP.
Password:Specifythepasswordwhichisprovidedbyyour
ISP,andthenverifyitonceagain
inthenextfield.
ServiceName:SpecifythenameoftheISP.
Type: Select a reconnection type: Keep Alive (A connection to the Internet is always
maintained), Connect on Demand: You have to open up the Web‐based management
interface
and click theConnectbutton manually any timethat you wishto connect to the
Internet.
Domain Name Service: Select Get Automatically from ISP if the ISP will provide the DNS
address, if not, select Use these DNS servers and specify the primary and secondary DNS
serverIPaddress.
ClickontheApplybuttontosavethechanges.
To Next Page
Loading...
