EnGenius EOC1650 - 7.6.1 Administration

EnGenius EOC1650 Wireless Access Point / Client Bridge Version 2.0
68
7.6.1 Administration
 Click on the Administration link under the Management menu. This option allows you to 
create a user name and password for the device. By default, this device is configured
without a user name and password admin. For security reasons it is highly recommended
thatyoucreateanewuser
nameandpassword.


 Name:Specifyausernameintothefirstfield.
 Password:Specifyapasswordintothisfieldandthenre‐typethepasswordintotheConfirm
Passwordfield.
 RemoteManagement:Choosetoenableordisableremotemanagement.
 RemoteUpgrade:Choosetoenableordisableremot e
firmwareupgrade.
 Remote Management Port: Specify a port for remote management. For example, if you
specify8080,thenyouwillneedtospecify<IPaddress>:<port>192.168.1.1:8080toconnect
tothewebinterfaceofthedevice.
 ClickontheApplybuttontosavethechanges.


7.6.2 SNMPSettings
 Click on the SNMP Settings link under the Management menu. This option allows you to
assignthecontactdetails,location,andcommunitynameandtrapsettingsforSNMP.Thisis
anetworkingmanagementprotocolusedtomonitornetwork‐attacheddevices.SNMPallows
messages (called protocol data units) to be sent
 to various parts of a network. Upon 
receiving these messages, SNMP‐compatible devices (called agents) return data stored in
theirManagementInformationBases..