EnGenius EOC1650 - 7.3 System; 7.4 Router; 7.3.1 System Properties; 7.4.1 WAN Settings

EnGenius EOC1650 Wireless Access Point / Client Bridge Version 2.0
58

7.3 System
 ClickontheSystemlinkonthenavigationdrop‐down
menu. You will then see System Properties setting,
whichisdescribedbelow.



7.3.1 SystemProperties
 Click on the System Properties link under the System drop‐down menu. This page allows
you to switch the operating mode of the device, as well as specify a name and select the
operatingregion.



 DeviceName:Specifyanameforthedevice(thisisnottheSSID),
 Country/Region:Selectacountryfromthedrop‐downlist.
 Operating Mode: Select operating mode.  Configuration for each operating mode is
describedintheirrespectivechapters.
 ClickontheApplybuttonto
savethechanges.


7.4 Router
 Click on theRouter link onthe navigation drop‐down
menu.Youwillthenseethreeoptions:WANsettings ,
LAN settings, and VPN Pass Through. Each section is
describedindetailbelow.


7.4.1 WANSettings
 ClickontheWAN SettingslinkundertheRouterdrop‐downmenu.Thispageallowsyouto
configuretheWANinterfaceasDHCP,StaticIP,PPPoEorPPTP.


