Rev. A Handling and Maintenance 3-17
TM-U950/U950P Technical Manual
Tool List
26 Four dowels of frame-inner G-15
27 Lever-sub slip paper feed shaft contact portion with roller-sub slip paper feed G-15
28 Iron core notch G-15
29 Contact portion of form stopper and lever-sub slip paper feed shaft G-15
30 Contact portion of J/S changeover solenoid mount plate and J/S changeover solenoid G-15
31 Shaft of frame-paper take-up sub assembly G-36
32 Two U-cut notches of frame-paper take-up sub assembly G-36
33 Paper take-up gear contact portion with Paper take-up spring G-36
34 External surface of paper take-up spring G-36
35 Six shafts of frame-main assembly G-36
36 Roller-sub slip paper feed assembly mounting two U-cut notches of frame-main assembly G-15
37 Gear of roller-slip paper feed assembly G-36
38 Paper feed deceleration gear G-36
39 Receipt transmission gear G-36
40 Notch of J/S changeover gear G-36
41 Paper feed deceleration gear G-36
42 Bigger wheel gear of gear-journal transmission G-36
43 Two axles of roller-MICR head holder G-36
44 Notch in sleeve of roller-MICR head holder G-36
Table 3-4. Tools Required for Servicing the Printer (all are commercially available)
Tool Name
Brush #1
Brush #2
Cleaning brush
Phillips screwdriver no. 1
Phillips screwdriver no. 2
Flatblade screwdriver
Hexagon screwdriver 5 mm (0.2”)
Tweezers
Round-nose pliers
Clearance gauges, 0.5 mm (0.02”)
ET holders (#1.5, #2.3, and #3)
Table 3-3. Lubrication Points for Printer Mechanism Unit (for printers with an MICR reader)
No. Lubrication Point (See lubrication point diagrams at end of Chapter 6 (Appendix) Type
CONFIDENTIAL
To Next Page
Loading...
