Rev. A Features and General Specifications 1-31
TM-U950/U950P Technical Manual
Blinking: Stand by for slip paper insertion
Functions
Error Processing
Error detection
When the printer detects an error, it carries out the following operation sequence:
❏ All running operations are stopped.
❏ The printer goes off-line
❏ The ERROR LED flashes. (See Error Types and Countermeasures on page 4-23.)
Error recovery
The commands DLE ENQ 1 and DLE ENQ 2 are used to recover from a recoverable error (*1).
Notes
❏
If slip paper is selected and DLE ENQ 1 is used to recover from a recoverable error, the printer ejects
the remaining slip paper and repeats the loading process.
❏
When recovering from a slip paper eject error, the printer ejects the paper but does not repeat loading.
❏
When the printer recovers from an error using DLE ENQ 2 while slip paper is selected, the printer
first ejects the slip, then goes to 2-sheet mode.
❏
When an unrecoverable error (*2) has occurred, turn off the printer as soon as possible.
(*1) Errors (6) to (10) in Table 4-5 in Chapter 4 are the recoverable errors.
(*2) Errors (1) to (5) in Table 4-5 in Chapter 4 are the unrecoverable errors.
Blinking pattern
Blinking: Stand by for slip paper removal
Blinking pattern
Blinking: Personal check waiting state (when the printer is
used with the MICR reader)
CONFIDENTIAL
To Next Page
Loading...
