7 Basic Manual Control 107
[Next] and [Last]
The [Next] and [Last] buttons increment and decrement channel selection. If only one channel is
selected, [Next] increments the channel selection to the next sequential channel, while [Last]
decrements the channel selection by one.
Select channel 10 then change the selection to channel 11 using the [Next] key:
• [1] [0] [Enter]
Channel 10 is selected with a gold outline around the entire channel and the channel
number is indicated in white.
•[Next]
Channel 11 is now selected with a gold outline and white channel number while channel 10
is no longer selected.
If there is no specific channel selected when [Next] or [Last] is pressed, channel 1 is selected.
When a group of channels is selected, pressing [Next] or [Last] selects the first or last channel in
the channel list.
For Example:
Channels 11 through 20 are selected:
•[Next]
Channels 11 through 20 are still the specified channel list but only channel 11 is selected
for control. You can now sequentially press [Next] or [Last] to cycle through the list. Press
[Select Last] to reselect the entire range.
Note:
[Next] and [Last] work with the current flexichannel state. See “Using
Flexichannel” on page 41.
To Next Page
Loading...
