298 Eos Operations Manual
Time Code
Eos has time code functionality based on a timing source and a list of events that execute at
specific times of that timing source. You can compile event lists and have them play back later while
following a timing source.
Time code lists can receive timing data from either SMPTE or MIDI sources. Eos accepts up to 32
SMPTE sources and 32 MIDI Time Code (MTC) sources (each are numbered from 1-32).
Enabling Time Code
Eos has global enablers for MIDI Time Code and SMPTE. These are found in Setup, Show Control,
page 96.
If the MIDI Time Code setting is disabled, all MTC event lists are disabled as well. Each event list
can be enabled/disabled using the internal and/or external field. Off is disabled, regardless of the
global setting.The same is true for SMPTE.
Timing Data
Timing data is given in the form of (hours) : (minutes) : (seconds) : (frames). Therefore a timing
value of 06:25:15:20 would be 6 hours, 25 minutes, 15 seconds, 20 frames.
The number of frames per second is determined by the timing source and the event list must be set
to this same number of frames when programming. Number of frames can be 24, 25, or 30.
Color coding
The color of the time in the “Status” column of the event list display indicates the source of the
timing data. The colors and indications are:
Green - Valid external timing is being received.
Red - The internal clock is the data source and is running.
Grey - No timing data is available.
To Next Page
Loading...
