7 Basic Manual Control 125
Home
Eos is equipped with a [Home] hardkey. As with the {Home} touchbutton on the Encoder LCD (see
Home, page 117) this hardkey allows you to home a specific parameter. Additionally, you may home
all of a channel’s non-intensity parameters or home only a specific category (I, F, C, B).
Homing a channel, category, parameter, or submaster will return it to the default value.
• [1] [Home] [Enter] - homes all parameters for channel 1, except intensity.
• [1] [Color] [Home] [Enter] - homes all color parameters for channel 1.
• [Group] [1] [Color] [Focus] [Home] [Enter] - homes the color and focus parameters of all
channels in group 1.
• [Sub] [1] [Home] [Enter] - homes submaster 1.
• [Sub] [1] [Thru] [Home] [Enter] - homes all submasters.
You can select a preset to provide home values for all non-intensity parameters (instead of fixture
library default values) when home commands are used. Store a preset with modified home values
for only the channel parameters you would like at a different value than default. And then assign
that preset to Home in Setup (see Show Settings, page 93). Intensity will disregard the preset
value. Any channels that are not included in the preset assigned to Home in Setup will use their
library defaults.
To Next Page
Loading...
