272 Eos Operations Manual
About Address
Press [About] to put the CIA into “About” mode. When an address is selected, the information
below is displayed: You can select the information you wish to view from the five buttons located on
the right side of the CIA. The buttons are:
{Address} displays the following information:
• Address number (displayed as straight address and port/offset)
• Dimmer label (if any)
• Associated channel number, which is a hyperlink to the [About] channel display.
• Part number (if any)
• Notes
• Output value (ACN, Net2, ArtNet, Avab UDP, or DMX)
• Current output value and source of output
• Parameter controlled by the address
•Home Value
• Basic patch information
• Extended patch information (if available)
• If it is a scroller, color/gobo wheel, the assigned scroll or wheel is indicated
{Next Part} & {Last Part} will advance to the next part or go back to the previous part. These
buttons only display for addresses with parts.
{Go To Patch} is a shortcut to edit the patch for the address selected. This will open up the patch
display.
{Lamp Controls} displays controls for the lamp or other parameters of the device (if it is a moving
light).
{Address Check} will bring current address to full.
{Next/Last Unpatched} will allow you to see what addresses closest to the current address are
currently unpatched.
To Next Page
Loading...
