7 Basic Manual Control 133
“Select” Keys
Select Last
The [Select Last] key allows you to reselect whatever the previous channel selection was. This
includes multiple channel selections, groups, etc. Using [Select Last] [Select Last], Eos will recall
your last command line and leave it unterminated for further operation.
Select Manual
The [Select Manual] key is used to select all channels that currently have manual data. You may
use [Select Manual] combined with the parameter control keys to capture only certain parameters
of a channel with manual data.
The following examples illustrate the various methods to select channels using [Select Manual]:
• [Select Manual] [Enter] - selects all channels with manual data.
• [Select Manual] [Color Palette] [1] [Enter] - selects all channels with manual levels and sets
them to color palette 1.
• [Color] [Select Manual] [Color Palette] [1] [Enter] - selects only channels with manual color
values and sets them to color palette 1.
• [1] [thru] [1] [0] [0] [Select Manual] [Enter] - selects channels between 1 and 100 with
manual data.
• [Select Manual] [Record] [Group] [n] Enter] - records channels with manual data to the
target group.
Select Active
The [Select Active] key is used to select all channels that currently have intensity levels above
zero.
The following examples illustrate the how to select channels using [Select Active]:
• [Select Active] [Enter] - selects all active channels with intensity levels above zero.
• [Select Active] [Record] [Group] [x] [Enter] - records active channels to the target group.
• [Select Active] [Sneak] [Enter] - selects all channels with intensity above zero and restores
manual control to the background state, using default sneak time, if enabled.
• [1] [Thru] [1] [0] [0] [Select Active] [Enter] - selects channels between 1 and 100 with
intensity levels above zero.
Select All
Pressing [Select Active] twice will post Select All to the command line. This can be used to select
all of the channels.
Note:
If any manual control action is taken immediately after a [Record], [Record Only],
or [Update] command, the previously selected channels will automatically be
reselected.
To Next Page
Loading...
