110 Eos Operations Manual
Setting Intensity
Channel intensity may be manually entered from the keypad, set with an intensity palette (if
programmed) or set with the level wheel. Pressing [At] after channel selection assumes an
intensity value will be added to the selected channels. You may also use the [Full] button to bring
the selected channels to their full intensity or you may use the [Out] button to fade the intensity out.
Use the [Level], [+%], and [-%] keys to affect the intensity value of selected channels. Each of
these keys are set at a specific value established in the Setup ({Manual Control}, page 99).
• [Level] is set by default to full (100% intensity).
• [+%] and [-%] are each set by default value of 10 points.
The following examples illustrate the various methods of setting intensity:
• [1] [+] [3] [At] [5] <0> [Enter] - selects channels 1 and 3, and sets an intensity level of 50%.
• [1] [Thru] [5] [-] [4] [Full] [Enter] - selects a range of channels 1 through 5, except channel
4, and sets the intensity to full.
• [1] [Thru] [8] [At] [+] [3] [Enter] - adds 30% to all intensities in the channel selection. If they
were at 50, they will now be at 80. If channels 1, 3 and 5, were at 30 and 4 was at 50, they
would be 60% and 80% intensity, respectively.
• [5] [Thru] [8] [At] [/] [3] [Enter] - scales the intensities of the selected channels in the list
down 30% of their current values.
• [1] [Thru] [4] [At] [/] [1] [3] [0] [Enter] - scales the intensities of the selected channels in the
list up 30% of their current values. If channels 1 through 4 were at 40% intensity, this would
scale them up by 30% to a value of 52.
• [2] [+] [5] [level wheel] - roll the wheel up for greater intensity or down for less intensity.
• [1] [Level] - selects channel 1 and sets it to the level as established in Setup.
• [Group] [9] [Out] - selects all channels in Group 9 and sets the intensity values for those
channels to zero.
• [1] [0] [At] [At] - selects channel 10 and sets an intensity level of full.
To Next Page
Loading...
