2 System Installation 19
Chapter 2
System Installation
This chapter describes the placement of Eos in a few lighting system risers. It also details
connection of the various components of your Eos hardware.
This chapter contains the following sections:
• Basic System Risers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
• Large System Riser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21
Note:
In order to output control levels from your console, you must connect a Net3
gateway, Net2 node, or connect to a device that receives Net3 or ETCNet2
directly. Either of these devices must be given an IP address before it can function
with Eos. This is done using NCE (Network Configuration Editor) and a Windows®
PC. The NCE Software CD and related user manuals and setup guides shipped
with your gateway or node. Use these materials to prepare your gateway or node
for use with Eos.
To Next Page
Loading...
