7 Basic Manual Control 111
As long as channels are on the command line you can continue to address them with commands
without having to reselect them.
For Example:
• [1] [thru] [5] [Full] [Enter]
The selected channels are highlighted in gold, with white channel text and red intensity
values (indicating manual data). You may continue to modify channels 1 through 5 since
they are still selected and displayed on the command line.
• [-%] [-%]
This command would reduce the intensity of channels 1 through 5 by 20%. This command
is self-terminating.
• [at] [7] [5] [Enter]
You can continue manipulating the selected channels so long as the channels are selected and
displayed on the command line.
Level Wheel
You may set intensity for selected channels or addresses using the level wheel. Rolling the level
wheel upwards increases intensity. Rolling it downwards (towards you) decreases it.
To Next Page
Loading...
