ETC EOS - Create a New Macro from the Display

292 Eos Operations Manual
Create a New Macro from the Display
From the macro editor display, enter any unrecorded macro number from 1 to 1000 and press
[Enter]. Your new macro number will display in the macro list in numerical order but will not have a
label or any contents.
To store the macro contents, select the macro and press {Edit}. A cursor appears flashing in the
macro content detail portion of the display, ready for you to add the macro content.
For Example:
Create macro 3. Write the instruction to set all active channels to 50%, then sneak them to
their original levels over 10 seconds and last, link to macro 5.
• <Macro> [3] [Enter]
•{Edit}
• [Select Active] [At] [5] [Enter]
• [Sneak] [Time] [1] [0] [Enter]
• [Macro] [5] [Enter]
• [Select]
While in macro edit mode, all keys are entered as content except the macro editor softkeys, arrow
keys, [Escape], [Select] and [Learn] keys.