24 Eos Operations Manual
Power
Power Up the Console
Step 1: Attach the appropriate power cable to the IEC connector on the rear of the console.
Step 2: Press the I/O switch (I is “on”) next to the IEC connector on the rear of the console to
turn power on. This will provide power to all internal electronics.
Step 3: Press the power button, located in the top right corner of the console, beneath the Eos
logo. The button LED will illuminate blue to indicate the console is running. The
console will boot up into the Eos environment. The Eos system is now ready for use.
Power Down the Console
Step 1: After saving your show (see below), in the browser menu select File < Power Off
Console. A dialogue box opens asking you to confirm.
Step 2: Confirm this command by pressing {OK} in the dialog box. The console will power
down.
Note:
In the future, you may go straight to the welcome screen by adjusting a setting in
the ECU. See Show Welcome Screen, page 315 in the ECU appendix.
Note:
Eos is a persistent storage console. Therefore if you shut down your system
without saving the show file, you will return to the same place in your show when
you reboot.
To Next Page
Loading...
