ETC EOS - Storing and Using Macros

21 Using About 273
{Sensor AF} - appears when the current address is patched to a dimmer in an ETC Sensor rack.
Sensor feedback must be enabled. See Enable Sensor Feedback, page 319 for more information.
{Sensor AF} displays the following information:
• Sensor dimmer name
• Dimmer module type
• Rack/Position
• Rack dimmer level (displayed as a percentage)
• Rack dimmer source
{Sensor AF} displays the following information, which can be modified from Eos:
•Mode
•Curve
• Threshold
• Scale Minimum
• Scale Maximum
• Preheat
• Preheat Timing
• Advanced Features (AF)
The following buttons will also be displayed:
• {Set Dimmer} sets that dimmer to an intensity.
• {Unset Dimmer} unsets a dimmer.
• {Clear Errors} clears any dimmer errors that are present for that address.
Note:
For Sensor feedback, the CEM+ must be running software version 3.0 or later.
Note:
Clearing CEM+ errors from Eos will be temporary unless the errors have been
fixed at the CEM+. Errors displayed on Eos will clear on their own once they have
been cleared from the CEM+. Some CEM+ errors can only be cleared at the
CEM+.