274 Eos Operations Manual
{Device Details} - appears when the current address is patched to a RDM device. RDM devices
must be enabled through the ECM and discovered through the patch. See Enable RDM, page 319
and {Patch} Display and Settings, page 74.
{Device Details} displays the following information and allows some changes to be made to:
• Device Label (displayed at the top by the address number)
• DMX Address (can be changed in this display by clicking on the property or value)
• DMX Label (same as the device label, but the label can be changed here by clicking on
the property or value)
• Type
• Manufacturer
• Device ID
•Footprint
• Version
• Lamp State
• Lamp Hours
• Head DC Voltage
• Lamp On/Off
• Gel Distance Traveled
• Gel2 Distance Traveled
•Fan RPM
• Ambient Temperature
• Gel Temperature
• Device Errors (will only display if there are current errors)
• Clear Errors
Device Errors are displayed in four different colors depending on severity.
• Gray - unknown or not an error
• White - Advisory
• Yellow - Warning
•Red - Error
Note:
Changes may take a few seconds to make. They will propagate to the RDM device
and then back to the console’s patch and about displays.
Note:
Changing the address can not cause any part of the fixture to move to a different
universe or communication with the device maybe loss. The universe is set into
the gateways port configuration.
Note:
Color severity is determined by the device manufacturer.
To Next Page
