Overture Software Manual
Page 2-14
Revision 1.5 USING OVERTURE
The user can perform the following actions:
• Create Playlist enables the user to create a playlist that consists of multiple media elements.
Section 2.2.4.1 describes how to create a playlist.
• View will display the media files in the full format, simple list, or thumbnails.
• Open enables the user to open a media file. The design canvas window will open once a file is
selected.
• Preview enables the user to preview static and animated logos only. A preview window will
open and play out the static or animated sequence.
• Copy enables the user to copy media files from the Media Library.
• Paste enables the user to paste media files into the Media Library.
• Delete enables the user to remove media files from the Media Library.
• Refresh will refresh the view of the selected window.
2.2.4.1. Creating a Playlist
A playlist will allow the user to combine a number of media elements into one file. The playlist can
contain up to 8 media elements. Figure 2-19 shows the Playlist Editor. The user can add or delete
media files (.wav or .evl) as shown in Figure 2-20. . Once saved, a playlist file (.ekp) is created.
In order to use the playlist, the user must load the playlist file (.ekp) AND the corresponding media onto
the same drive of the device. The user can then use either Overture or the front control panel to call
the playlist to air.
"
For the playlist to work properly, the files within the playlist MUST also be on
the device. The user MUST transfer these files to the device.
To Next Page
Loading...
