evertz Overture - Creating Animated Logos

Overture Software Manual
USING OVERTURE Revision 1.5 Page 2-51
2.9.1. Temperature Menu
The Temperature menu provides the following options shown in Figure 2-67. The choices available
are:
• Format enables the user to set the format of the temperature.
• Increase font size enables the user to increase the font size of the temperature by a single
increment at a time.
• Decrease font size enables the user to decrease the font size of the temperature by a single
decrement at a time.
• Font… enables the user to specify the font type of the temperature.
• Font Colour… enables the user to set the font colour of the temperature.
• Font Transparency… enables the user to set the temperature font’s opacity of the
temperature. The range available is 0 to 255.
• Font Size… enables the user to set the font size of the temperature.
• Delete enables the user to remove the temperature.
"
In order for the Temperature to function properly, the user MUST ensure the
selected Font Type is loaded onto the device.
2.10. Creating an Animated Logo
2.10.1. Frame Panel
The frame panel identifies all the frames that have been imported into the design canvas (see 2.3.1.5).
The sequence of frames is in exactly the same order that the files where inserted into the design
canvas (whether manually or automatically). These are frames that can be used to create an animated
logo.
"
When more than one frame is inserted into the Design Canvas, Overture will
automatically start the Sequence Editor. Overture assumes that the user is
going be creating an animated logo.