EasyManua.ls Logo

evertz Overture - Page 54

Default Icon
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Overture Software Manual
Page 2-44
Revision 1.5 USING OVERTURE
Push enables the user to use a push transition between headlines, where the direction is set by
Direction.
Anchor Left sets the alignment of the text to be left justified. Text starts from the anchor point
in the text box. See Figure 2-62 for an example of the anchor point.
Anchor On Center sets the alignment of the text to be centered. Text will be centered on the
anchor point in the text box. See Figure 2-62 for an example of the anchor point.
Anchor Right sets the alignment of the text to be right justified. Text ends at the anchor point
in the text box. See Figure 2-62 for an example of the anchor point.
Increase font size enables the user to increase the font size of the text by a single increment at
a time.
Decrease font size enables the user to decrease the font size of the text by a single decrement
at a time.
Font… enables the user to specify the font type of the text.
Font Colour… enables the user to set the font colour of the text.
Font Size… enables the user to set the font size of the text.
Use Font Outline enables the user to add an outline to the text.
Outline Colour… enables the user to set the colour of the font outline.
Use Font Shadow enables the user to add a shadow to the text.
Shadow Colour… enables the user to set the colour of the shadow around the text.
Shadow Depth… enables the user to set the depth of the shadow around the text. The range
of the shadow depth is from 1 to 16 pixels in each the X and Y direction.
Set Transition Duration… enables the user to set the duration of the transition in frames. The
transition time range is from 1 to 60 frames.
Set Transition Hold Time… enables the user to set the duration of the transition in frames.
The transition hold time range is from 1 to 65535 frames.
Set Text Source File… enables the user to specify the source of the text file. The text file is a
normal text that contains the headlines.
Delete enables the user to remove the Design Object.

Table of Contents

Related product manuals