Test Setup - Test Configurator, Timer, and System
182 88000 Series
eCPRI Flow - Profile
QoS Thresholds
Note: For Dual Port topology in One-Way P<m> P<n>, these settings are
coupled.
Global Pass/Fail Verdict check box when selected (default) allows
enabling and configuring each metrics individually, otherwise all
pass/fail verdicts are disabled.
Latency check box when selected (default) enables the latency
pass/fail verdict and allows setting the maximum threshold delay
per direction when applicable.
For One-Way Latency: 1 to 500 000 μs (default is 100 μs).
For Round-Trip Latency: 1 to 1000 000 μs (default is 200 μs)
Jitter check box when selected (default) enables the jitter pass/fail
verdict and allows setting the maximum threshold value per
direction when applicable: 1 to 500 000 μs (default is 10 μs).
Frame Loss Rate check box when selected (default) enables the
Frame Loss pass/fail verdict and allows setting the frame loss rate
for the port: 0.0E-00 to 5.0E-02 (default is 1.0E-07). However
entering a value of 0.0E-00 or below 1.0E-14 is treated as a pass/fail
verdict based on loss count instead of rate.
Throughput check box when selected (default) enables the
throughput pass/fail verdict and allows setting the minimum and
maximum threshold values for the port.
To Next Page
Loading...
