EXFO Power Blazer - Page 241

Test Setup - Test Configurator, Timer, and System
Power Blazer 231
Interface
RP3 Address (OBSAI Framed L2)
 Source identifies the source node of RP3 messages: 0000 to 1FFF;
default is 1234. The RP3 address 1FFF corresponds to the empty
message address that is dropped according to the standard.
 Target identifies the peer node that is receiving the RP3 messages:
0000 (default) to 1FFF.
 Peer Target indicates the RP3 Peer Target Address; indicates a
mismatch when displayed in red.
 Address Mismatch check box when selected, cleared by default,
enables the monitoring of the mismatch between the Source and
received Peer Target addresses.
RP3 Message (OBSAI Framed L2)
 Type identifies the type of RP3 Data Message generated by the OBSAI
node: WCDMA/FDD (00010) - (default), LTE (01110), GSM/EDGE
(00100), and 802.16 (01100).
 Msg Grp/Frame (N_MG) indicates the number of Message Group per
Frame parameter.
 Msg/Grp (M_MG) indicates the number of Message per Message
Group parameter.
 Idle/Grp (K_MG) indicates the number of Idle per Message Group
parameter.
ESMC
Note: Available with Wander test application with SyncE rates.
Generated QL allows the selection of the QL message that will be
generated. See page 512 for the list of QL message (default is
QL-DNU/DUS).