Test Setup - Test Configurator, Timer, and System
234 88000 Series
Interface
Min RX Power (dBm) indicates, when supported, the minimum
received power level of the optical laser/lane in dBm.
Max RX Power (dBm) indicates, when supported, the maximum
received power level of the optical laser/lane in dBm.
Laser ON/OFF button, available with parallel interfaces, is used to
activate the laser control per optical lane or for all lanes.
Optical lane numbers are from 0 to 3 or 0 to 7 depending on the
selected interface/rate.
All Lanes check box, when selected, applies the change(s) to all
optical lanes at once.
Optical Lane indicates the optical lane numbers and All which
represents the setting for all optical lanes when the All Lanes
check box is selected.
Laser check box, when selected, indicates that the corresponding
optical laser lane is activated and emitting an optical laser signal.
Laser OFF at Start-Up check box when selected, cleared by default,
automatically turns OFF the laser for serial interfaces or all lasers for
parallel interfaces when starting the module or when switching from
one test application to another; this applies on both ports for Dual Port
topology. However the laser remains ON, on a remote module
receiving a request for a DTS connection or a loopback command.
To Next Page
Loading...
