Test Setup - Test Configurator, Timer, and System
Power Blazer 235
Interface
Modify Wavelength button, available with tunable transceivers when
the TunableOptics
software option is enabled, is used to configure the
transceiver wavelength.
Wavelength (nm) indicates the actual wavelength value selected.
Use the scroll box and/or the -/+ buttons to select the wavelength.
The minimum and maximum wavelength values are displayed.
Channel Number indicates the actual ITU channel number based
on ITU Grid.
Frequency (THz) indicates the actual Frequency based on ITU Grid
Channel Spacing (GHz) indicates the difference in frequency
between two adjacent channel detected from the transceiver
device.
Restore Previous restores the current value present in the
transceiver device.
Power Range (dBm) indicates the transceiver operational RX power
range.
FEC (FlexO BERT)
FEC check box when selected (default) enables the FEC in TX/RX and
allows detecting, reporting, and correcting up to 15symbol errors
(Correctable) per codeword. If there are over 15 symbol errors
detected, they are reported as uncorrectable errors.
To Next Page
Loading...
